Compact FTR Mini-Manual. Size, x8 inches. Twelve high-quality laminated pages, loaded with detailed instructions covering all aspects of operating. FTR/E Technical Supplement Dual Band FM Transceiver FTR/E Technical Supplement Introduction This manual provides technical. Yaesu FTR Amateur Transceiver. #, Nifty Mini Manual, MINI MANUAL, Nifty spiral bound mini-manual contains 12 laminated pages [ x 8 inch].

Author: Vogore Tudal
Country: Cape Verde
Language: English (Spanish)
Genre: History
Published (Last): 2 July 2014
Pages: 416
PDF File Size: 16.90 Mb
ePub File Size: 15.2 Mb
ISBN: 531-7-86471-664-2
Downloads: 7992
Price: Free* [*Free Regsitration Required]
Uploader: Bagis

See page 62 for details. Menu 15 [ EDG. While the MHz shift will be kHz; on 70 cm, the shift may tf 1. Wx Priority WX Priority 1.

Avoid heating vents and window locations that could expose the transceiver to excessive direct sunlight, especially in hot climates. Memory Only Mode 3. Press or hold in either of these buttons to tune or scan up or down the operating frequency or ,anual the memory channels.

When the Memory Bank feature is activated, the FTR will check the lowest memory channel in the Memory Bank as the priority channel. By pressing ‘print’ button you will fy only mqnual page.

In the event of extreme weather disturbances, such as storms and hurricanes, the NOAA National Oceanic and Atmospheric Administration sends a weather alert accompanied by a Hz tone and subsequent weather report on one of the NOAA weather channels. You can also program in the power level you wish to use on each memory by setting the power level while in VFO mode. Page of 84 Go.

Depends on the band of operation. Menu 42 [ SQL. Read the manual completely. Programmable band Limit Memory Scan 7. Selects or disables the VFO band edge limiting for the current band. Use the following procedure to activate the Set Menu mode: When this happens, it may be that the other station is not sending any tone.


However, if you need to change the channel step increments, the procedure to do so is very easy; 7090r suggest you make out a list of the repeaters and simplex frequencies you wish to program along with the tones needed.

The number flashing will be the next available empty memory slot. Consult your Yaesu dealer for details regarding these and any newly-available options Connection of any non-Yaesu- approved accessory, should it cause damage, may void the Limited Warranty on this appa- ratus. Amnual DTMF Autodialer memories can store up to 16 digits of a telephone number for repeater autopatch or other uses. Push the button down and hold until the function you are looking for manua up on the display.

Welcome to

In many ways, these buttons emulate the function of the rotary DIAL knob. Cw Identifier Setup Other external speakers may be used with the FTR, if they present the specified 8-Ohm impedance and are capable of handling the 2 Watts of audio output supplied by the FTR. If that is the memory you wish to fill, then push VM-MW momentarily to program that slot.

Rear Panel Connections 10 Amperes continuous duty. To clone from one transceiver to another, use the following procedure: Operation is subject to the following two conditions; 1 This device may not cause harmful interference, and 2 this device must accept any interference including received, interference that may cause undesired operation. The number of steps to program one memory may seem excessive, but you will quickly become adept at knocking them out very speedily once you get used to the system.


Specifications AF Output Impedance: Repeat above steps as needed to load each memory. Packet Interface Cable Availability of accessories may vary. Page 72 Disable the beeper. The transceiver may be installed in almost any location, but should not be positioned near a heating vent nor anywhere where it might interfere with driving either visually or mechani- cally.

Miscellaneous Settings the default selection. Enter the transmit and receive fre- quencies separately, as shown on page Mount the transceiver where the display, controls, and microphone are easily accessible, using the supplied MMB mounting bracket.

To print the manual completely, please, download it.

Yaesu FT-7900R Mini-Manual

If you have trouble getting your FTR to respond correctly during packet operation, check to be certain that you do not have Menu 26 PKT. Rotate main dial to select tone frequency. Press and hold in the [ S. You can add HTML directly into this manusl to render on the page. Regular Memory Channel Operation 4. The pin connections of the Data connector are shown below. To return to normal operation, repeat the above steps. FM carrier in order to activate the repeater.

Notting HillVictoria, Australia.